Examinando por Autor "Johnson, J. R."

Mostrando 1 - 4 de 4

Acceso Abierto
Origin and composition of three heterolithic boulder- and cobble-bearing deposits overlying the Murray and Stimson formations, Gale Crater, Mars
(Elsevier BV, 2020-06-06) Wiens, R. C.; Edgett, K. S.; Stack, K. M.; Dietrich, W. E.; Bryk, A. B.; Mangold, N.; Bedford, C.; Gasda, P.; Fairén, Alberto G.; Thompson, L.; Johnson, J. R.; Gasnault, O.; Clegg, S.; Cousin, A.; Forni, O.; Frydenvang, J.; Lanza, N.; Maurice, S.; Vasavada, A. R.; Centre National D'Etudes Spatiales (CNES); European Research Council (ERC); Payre, V. [0000-0002-7052-0795]; Frydenvang, J. [0000-0001-9294-1227]; Johnson, J. [0000-0002-5586-4901]; Gasnault, O. [0000-0002-6979-9012]; Unidad de Excelencia Científica María de Maeztu Centro de Astrobiología del Instituto Nacional de Técnica Aeroespacial y CSIC, MDM-2017-0737
Heterolithic, boulder-containing, pebble-strewn surfaces occur along the lower slopes of Aeolis Mons (“Mt. Sharp”) in Gale crater, Mars. They were observed in HiRISE images acquired from orbit prior to the landing of the Curiosity rover. The rover was used to investigate three of these units named Blackfoot, Brandberg, and Bimbe between sols 1099 and 1410. These unconsolidated units overlie the lower Murray formation that forms the base of Mt. Sharp, and consist of pebbles, cobbles and boulders. Blackfoot also overlies portions of the Stimson formation, which consists of eolian sandstone that is understood to significantly postdate the dominantly lacustrine deposition of the Murray formation. Blackfoot is elliptical in shape (62 × 26 m), while Brandberg is nearly circular (50 × 55 m), and Bimbe is irregular in shape, covering about ten times the area of the other two. The largest boulders are 1.5–2.5 m in size and are interpreted to be sandstones. As seen from orbit, some boulders are light-toned and others are dark-toned. Rover-based observations show that both have the same gray appearance from the ground and their apparently different albedos in orbital observations result from relatively flat sky-facing surfaces. Chemical observations show that two clasts of fine sandstone at Bimbe have similar compositions and morphologies to nine ChemCam targets observed early in the mission, near Yellowknife Bay, including the Bathurst Inlet outcrop, and to at least one target (Pyramid Hills, Sol 692) and possibly a cap rock unit just north of Hidden Valley, locations that are several kilometers apart in distance and tens of meters in elevation. These findings may suggest the earlier existence of draping strata, like the Stimson formation, that would have overlain the current surface from Bimbe to Yellowknife Bay. Compositionally these extinct strata could be related to the Siccar Point group to which the Stimson formation belongs. Dark, massive sandstone blocks at Bimbe are chemically distinct from blocks of similar morphology at Bradbury Rise, except for a single float block, Oscar (Sol 516). Conglomerates observed along a low, sinuous ridge at Bimbe consist of matrix and clasts with compositions similar to the Stimson formation, suggesting that stream beds likely existed nearly contemporaneously with the dunes that eventually formed the Stimson formation, or that they had the same source material. In either case, they represent a later pulse of fluvial activity relative to the lakes associated with the Murray formation. These three units may be local remnants of infilled impact craters (especially circular-shaped Brandberg), decayed buttes, patches of unconsolidated fluvial deposits, or residual mass-movement debris. Their incorporation of Stimson and Murray rocks, the lack of lithification, and appearance of being erosional remnants suggest that they record erosion and deposition events that post-date the exposure of the Stimson formation.
Restringido
Photogeologic Map of the Perseverance Rover Field Site in Jezero Crater Constructed by the Mars 2020 Science Team
(Springer Link, 2020-11-03) Stack, K. M.; Williams, N. R.; Calef, F. J.; Sun, V. Z.; Williford, K. H.; Farley, K. A.; Eide, S.; Flannery, D.; Hughes, C.; Jacob, S. R.; Kah, L. C.; Meyen, F.; Molina, A.; Quantin Nataf, C.; Rice, M.; Russel, P.; Scheller, E.; Seeger, C. H.; Abbey, W. J.; Adler, J. B.; Amudsen, H.; Anderson, R. B.; Ángel, S. M.; Arana, G.; Atkins, J.; Barrington, M.; Berger, T.; Borden, R.; Boring, B.; Brown, A.; Carrier, B. L.; Conrad, Pamela G.; Dypvik, H.; Fagents, S. A.; Gallegos, Z. E.; Garczynski, B.; Golder, K.; Gómez, F.; Goreva, Y.; Gupta, S.; Hamran, S. E.; Hicks, T.; Hinterman, E. D.; Horgan, B. N.; Hurowitz, J.; Johnson, J. R.; Lasue, J.; Kronyak, R. E.; Liu, Y.; Madariaga, J. M.; Mangold, N.; McClean, J.; Miklusicak, N.; Nunes, D.; Rojas, C.; Runyon, K.; Schmitz, N.; Scudder, N.; Shaver, E.; SooHoo, J.; Spaulding, R.; Stanish, E.; Tamppari, L. K.; Tice, M. M.; Turenne, N.; Willis, P. A.; Aileen Yingst, R.; European Research Council (ERC); National Aeronautics and Space Administration (NASA); Molina, A. [0000-0002-5038-2022]; Hughes, C. [0000-0002-7061-1443]; Jacob, S. [0000-0001-9950-1486]; Arana, Gorka [0000-0001-7854-855X]; Sun, V. Z. [0000-0003-1480-7369]; Stack, K. [0000-0003-3444-6695]; Williford, K. [0000-0003-0633-408X]; Flannery, D. [0000-0001-8982-496X]; Gupta, S. [0000-0001-6415-1332]; Williams, N. [0000-0003-0602-484X]; Unidad de Excelencia Científica Centro de Astrobiología María de Maeztu del Instituto Nacional de Técnica Aeroespacial y CSIC, MDM-2017-0737
The Mars 2020 Perseverance rover landing site is located within Jezero crater, a similar to 50 km diameter impact crater interpreted to be a Noachian-aged lake basin inside the western edge of the Isidis impact structure. Jezero hosts remnants of a fluvial delta, inlet and outlet valleys, and infill deposits containing diverse carbonate, mafic, and hydrated minerals. Prior to the launch of the Mars 2020 mission, members of the Science Team collaborated to produce a photogeologic map of the Perseverance landing site in Jezero crater. Mapping was performed at a 1:5000 digital map scale using a 25 cm/pixel High Resolution Imaging Science Experiment (HiRISE) orthoimage mosaic base map and a 1 m/pixel HiRISE stereo digital terrain model. Mapped bedrock and surficial units were distinguished by differences in relative brightness, tone, topography, surface texture, and apparent roughness. Mapped bedrock units are generally consistent with those identified in previously published mapping efforts, but this study's map includes the distribution of surficial deposits and sub-units of the Jezero delta at a higher level of detail than previous studies. This study considers four possible unit correlations to explain the relative age relationships of major units within the map area. Unit correlations include previously published interpretations as well as those that consider more complex interfingering relationships and alternative relative age relationships. The photogeologic map presented here is the foundation for scientific hypothesis development and strategic planning for Perseverance's exploration of Jezero crater.
Acceso Abierto
Radiometric Calibration Targets for the Mastcam-Z Camera on the Mars 2020 Rover Mission
(Springer Link, 2020-12-03) Kinch, K. M.; Madsen, M. B.; Bell, J. F.; Maki, Justin N.; Bailey, P.; Hayes, A. G.; Jensen, O. B.; Merusi, M.; Bernt, M. H.; Sorensen, A. N.; Hilverda, M.; Cloutis, E.; Applin, D.; Mateo Martí, Eva; Manrique, J. A.; López Reyes, G.; Bello Arufe, A.; Ehlmann, B. L.; Buz, J.; Pommerol, A.; Thomas, N.; Affolter, L.; Herkenhoff, K. E.; Johnson, J. R.; Rice, M.; Corlies, P.; Tate, C.; Caplinger, M. A.; Jensen, E.; Kubacki, T.; Cisneros, E.; Paris, K.; Winhold, A.; European Research Council (ERC); Kinch, K. [0000-0002-4629-8880]; López Reyes, G. [0000-0003-1005-1760]; Manrique, J. A. [0000-0002-2053-2819]; Affolter, L. [0000-0002-2869-8522]; Unidad de Excelencia Científica María de Maeztu Centro de Astrobiología del Instituto Nacional de Técnica Aeroespacial y CSIC, MDM-2017-0737
The Mastcam-Z Camera is a stereoscopic, multispectral camera with zoom capability on NASA’s Mars-2020 Perseverance rover. The Mastcam-Z relies on a set of two deck-mounted radiometric calibration targets to validate camera performance and to provide an instantaneous estimate of local irradiance and allow conversion of image data to units of reflectance (R∗ or I/F) on a tactical timescale. Here, we describe the heritage, design, and optical characterization of these targets and discuss their use during rover operations. The Mastcam-Z primary calibration target inherits features of camera calibration targets on the Mars Exploration Rovers, Phoenix and Mars Science Laboratory missions. This target will be regularly imaged during flight to accompany multispectral observations of the martian surface. The primary target consists of a gold-plated aluminum base, eight strong hollow-cylinder Sm2Co17 alloy permanent magnets mounted in the base, eight ceramic color and grayscale patches mounted over the magnets, four concentric, ceramic grayscale rings and a central aluminum shadow post (gnomon) painted with an IR-black paint. The magnets are expected to keep the central area of each patch relatively free of Martian aeolian dust. The Mastcam-Z secondary calibration target is a simple angled aluminum shelf carrying seven vertically mounted ceramic color and grayscale chips and seven identical, but horizontally mounted ceramic chips. The secondary target is intended to augment and validate the calibration-related information derived from the primary target. The Mastcam-Z radiometric calibration targets are critically important to achieving Mastcam-Z science objectives for spectroscopy and photometric properties.
Acceso Abierto
SuperCam Calibration Targets: Design and Development
(Springer Link, 2020-11-26) Manrique, J. A.; López Reyes, G.; Cousin, A.; Rull, F.; Maurice, S.; Wiens, R. C.; Madariaga, M. B.; Gasnault, O.; Aramendia, J.; Arana, G.; Beck, P.; Bernard, S.; Bernardi, P.; Bernt, M. H.; Berrocal, A.; Beyssac, O.; Caïs, P.; Castro, K.; Clegg, S. M.; Cloutis, E.; Dromart, G.; Drouet, C.; Dubois, B.; Escribano, D.; Fabre, C.; Fernández, A.; Forni, O.; García Baonza, V.; Gontijo, I.; Johnson, J. R.; Laserna, J.; Lasue, J.; Madsen, S.; Mateo Martí, Eva; Medina, J.; Meslin, P.; Montagnac, G.; Moros, J.; Ollila, A. M.; Ortega, C.; Prieto Ballesteros, O.; Reess, J. M.; Robinson, S.; Rodríguez, Joseph; Saiz, J.; Sanz Arranz, J. A.; Sard, I.; Sautter, V.; Sobron, P.; Toplis, M.; Veneranda, M.; Agencia Estatal de Investigación (AEI)
SuperCam is a highly integrated remote-sensing instrumental suite for NASA’s Mars 2020 mission. It consists of a co-aligned combination of Laser-Induced Breakdown Spectroscopy (LIBS), Time-Resolved Raman and Luminescence (TRR/L), Visible and Infrared Spectroscopy (VISIR), together with sound recording (MIC) and high-magnification imaging techniques (RMI). They provide information on the mineralogy, geochemistry and mineral context around the Perseverance Rover. The calibration of this complex suite is a major challenge. Not only does each technique require its own standards or references, their combination also introduces new requirements to obtain optimal scientific output. Elemental composition, molecular vibrational features, fluorescence, morphology and texture provide a full picture of the sample with spectral information that needs to be co-aligned, correlated, and individually calibrated. The resulting hardware includes different kinds of targets, each one covering different needs of the instrument. Standards for imaging calibration, geological samples for mineral identification and chemometric calculations or spectral references to calibrate and evaluate the health of the instrument, are all included in the SuperCam Calibration Target (SCCT). The system also includes a specifically designed assembly in which the samples are mounted. This hardware allows the targets to survive the harsh environmental conditions of the launch, cruise, landing and operation on Mars during the whole mission. Here we summarize the design, development, integration, verification and functional testing of the SCCT. This work includes some key results obtained to verify the scientific outcome of the SuperCam system.